Instructions to Enable sata-ide mode for H8ssli under RedHat Linux Operating Systems

1. 
   In the command prompt, type the following at the command line and then install OS:
   

linux ide1=0xb080,0xb002 ide2=0xac00,0xa882 (2 SATA drives attached)

linux ide1=0xb080,0xb002 ide2=0xac00,0xa882 ide3=0xbc00,0xb882 (3 SATA drives attached)

linux ide1=0xb080,0xb002 ide2=0xac00,0xa882 ide3=0xbc00,0xb882 ide4=0xb800,0xb480 (4

SATA drives attached)

2. 
   During the GUI installation, in the “GRUB boot loader Configuration” section, check the “Configure advanced boot loader option” box, and press enter to the next step.
   
3. 
   In the “GRUB boot loader Configuration” page, type the following in the “General Kernel Parameters” field, then press next:
   

linux ide1=0xb080,0xb002 ide2=0xac00,0xa882 (2 SATA drives attached)

linux ide1=0xb080,0xb002 ide2=0xac00,0xa882 ide3=0xbc00,0xb882 (3 SATA drives attached)

linux ide1=0xb080,0xb002 ide2=0xac00,0xa882 ide3=0xbc00,0xb882 ide4=0xb800,0xb480 (4

SATA drives attached)

4. 
   Continue and finish the installation.
   

Note:

• 
  No driver required for enabling SATA-IDE mode